Elpro Technologies 455U-D Uživatelský manuál stáhnout pdf (Strana 82)

Appendix C S-Registers

Man_455U-D Rev 3.04 Page 83

S25 0-255 System Address –

Low Byte

The 16-bit system address uniquely identifies the

radio network

S26 0-255 Lead-In Tone Time This selects the Lead-In tone period – units 4 msec.

The default (10) should not normally be changed.

S27 0-255 Transmitter Hold-Up

Time

Selects How long the transmitter will stay on waiting

for more data before starting to send the tail (msec)

S28 0-255 Transmitter Tail

Time

Selects how long the transmitter will send a “Tail” at

the end of transmission. New data is ignored during

the tail time

S29 0-255 Unack Retries How many times to ret-transmit each message in

unacknowledged mode. Each message is transmitted

this number of times. The sequence number and

source address ensure that repeat messages are

ignored by the receiver.

S30 0-255 Ackmode retries Number of times to re-try in acknowledged mode if

no Acknowledge response is received.

S31 0-255 Radio Flags This read-Only register indicates radio Tx error flags

1 => Over-temperature Shutdown

2 => PTT Timeout

4 => PLL Out of lock

8 => Antenna failure

S32 0-255 Module Temperature This read-Only register indicates the module

temperature +50 (units C)

S33 0-1 Dual Redundancy

Status

2 = Active Primary

3 = Active Secondary

4 = Active Primary – no secondary detected

5 = Inactive Primary

6 = Inactive Secondary

S34 0-255 Battery Voltage This read-Only register indicates the voltage at the

battery input (Units 0.1V)

S35 0-255 Supply Voltage This read-Only register indicates the voltage at the

Supply input (Units 0.1V)

S36 System Channel

Duty Cycle %

1 2 ... 77 78 79 80 81 82

Komentáře k této Příručce

Žádné komentáře

Elpro Technologies 455U-D Uživatelský manuál Strana 82

Komentáře k této Příručce

Související produkty a manuály pro Sítě Elpro Technologies 455U-D